Question: What type of fluid pipe/duct are you using for this? I am currently using Ender IO Ender Fluid Duct which allows up to 8 liquids through the duct. Would it be better to one line of duct for import to the Reactor and Turbine and one line to the export's of the Reactor and Turbine?... Right now I have 11 turbines (7x7x16) and one Reactor (7x7x7) with an ME Network importing exporting the waste out of the Big Reactor so it moves smothly...

Here is my lay out and there will a link to imgur as well at the end.

I have the following: 11 Turbines (7x7x16). Each has an Advance Computer with a Wireless modem. This is followed up with a 12th Advance Computer with Monitor to see the settings of the turbines. http://www.computercraft.info/forums2/index.php?/topic/21430-active-cooled-big-reactor-turbine-pid-controller-with-master-control-and-monitoring/ Follow linke see Turbine Control and Master Controler.

01 Big Reactor (7x7x7) using EZ-Nuke's computer Craft Script to control the Control Rod Percentage. I also have 15 Coolant Ports, 1 Controler, 1 Computer Port. ( http://br.sidoh.org/#reactor-design?length=9&width=9&height=7&activelyCooled=true&controlRodInsertion=0&layout=10E3CX3C2E2CXCX2C2ECXCXCXC2EXCXCXCX2ECXCXCXC2E2CXCX2C2E3CX3C10E&modpack=direwolf20 )

13 Transfer Nodes (liquids) for my water from the ocean.

Here is the ImGur for my set up... http://marquerodin.imgur.com/all/

Now for my question: I am using Ender IO Ender Fluid Ducts which allows up to 8 liquids at a time through them. No mention of hot or cold so there is my issue, if you look at my Master Control Monitor you'll see some run with 0 and others with different numbers for the flow rate of steam and water. The EIO Fluid Duct has a 800 mB/t rate. Is there a better duct/pipe I can use? I have see the Thermal Dynamic Flux-Plated Fluiduct. Says transfer rate veries by liquid. Seeing as you're getting over 500k RF/t I wanted to know how you're pushing pulling your liquids between your reactor and turbines?