Does anyone know where to get this lamp?! I think it might be custom though :(

I'd go to home go to home and buy some wood for the base, a single gang electrical box, a single pole switch with a cover plate, an octagon electrical box, a piece of 14/2 wire, an length of properly rated extension cord with male end (cheap shit=fires), an LED bulb (to reduce heat/power use), and a small globe light fixture for the spirit bomb.

Screw two 2x4 on the sides of the electrical box (measure the figure and light to get the total lamp height you want, these will be the sides of the "tower" part of lamp) , then put a piece of plywood on the front and back. Drill a small hole near the top to run the 14/2 into the octagon wire clamp, then screw the octagon box near the top, lined up so you can access the holes of the octagon. Then run the 14/2 from the single gang box to the octagon, running the wire in the hollow cavity. Then from the bottom run the properly rated extension cord into the single gang box. Then cut a small mouse hole shape at the bottom so the lamp doesn't rest on the cord. This box is where your switch will be.

At the top, put a plywood cap on the top, and cut a few pieces of plywood to make a small box the screw onto the octagon to conceal it. Also make a front plate for the octagon box, cutting a hole just as big as the box opening itself (make sure you can access the corner screws) . Ideally the box should be flush with the front, not sticking out or pushed back at all. You then mount the small globe light fixture to to the octagon. Then simply mount the "tower" to a simple base about 1" thick, and 8x8 wide. If the lamp feels unsteady make the base bigger and heavier. Don't use it if it's tippy at all.

After you paint it you can install the switch and cover plate. Then glue Goku on and it should be done.

I'd like to point out I'm an electrican who does construction so I feel very comfortable doing things like this, but if you don't make sure to look up some youtube vids. Its super easy to do but you should still look up how to properly strip the wire, etc. This is just advice I haven't actually tried building this yet.

/r/dbz Thread Parent Link - imgur.com