Did you go through with it?

Guys, I did NOT delete my account. I deleted the post. This is why I deleted it. I did not want to encourage this.

Below is the tutorial. This is NOT MINE. I did it slightly different.

http://www.youtube.com/watch?v=fI9Q1...ature=youtu.be

Self-Bleeding Supplies and instructions A. 5/32” or 4mm OD polyurethane Tubing, preferably clear. you can get from McMaster or any hardware store B. 18 g. 1.5” long needle C. 16 oz. clear water bottle with cap D. Blood pressure cuff E. Alcohol and cotton

1) Prepare the bottle by poking two small holes on the cap, small enough to press fit the tubing in. 2) Cut one 3 feet long tubing and one 3.5 feet, then sterilize with alcohol, don’t overdo it! 3) Insert each tubing about 1 to 1.5 inch into the holes on cap and tape for security 4) Insert the 3 foot tubing open end into the 18 g. needle luer lock end and secure with medical tape 5) Put the blood pressure cuff on then add small amount of pressure. 6) Disinfect the entry site with alcohol very well then dry with cotton 7) Put the 3.5 foot long tube open end in your mouth 8) Pump the blood pressure cuff until your vein pops up, wait a minute or so. 9) Remove the needle safety cover off and insert the needle into the vein at a shallow angle, no need to go too deep. Hold in in position. 10) Now you can apply negative pressure to the bottle with your mouth to help blood move through. You can gauge the pressure by maintaining the bottle collapsed half way. 11) You can also make a fist on the drawing hand to help blood flow to the vein. 12) Once done you MUST first release the cuff pressure completely before pulling the needle out. 13) Get cotton ready, place it over the needle then pull the needle out. Apply pressure and hold for about a minute or so with your arm up. 14) Once the bleeding stops you can remove the cuff and wrap your arm with gauze. 15) Dispose of your blood in toilet.