Here is the output from the spoke routers -
 
Spoke1#show ip nhrp
10.XXX.XXX.3/32 via 10.XXX.XXX.3
   Tunnel220 created
3y33w, never expire
   Type: static,
Flags: used
   NBMA address: Old
ISP IP - that needs to be replaced
10.XXX.XXX.4/32 via 10.XXX.XXX.4
   Tunnel220 created
3y33w, never expire
   Type: static,
Flags: used
   NBMA address: Good
primary ISP IP
Spoke1#show ip nhrp map
  I/F     VPN address     NBMA address     Flag  
Tunnel100  (M)(E)          Good primary ISP IP     nhs           
Tunnel100  10.XXX.XXX.4    Good primary ISP IP    nhs           
Tunnel100  (M)(E)          Old ISP IP nhs           
Tunnel100  10.XXX.XXX.3    Old ISP IP       nhs           
Tunnel100:Proinfo TrustSec capability: False
 
Spoke1#show dmvpn
Legend: Attrb --> S - Static, D - Dynamic, I - Incomplete
        N - NATed, L -
Local, X - No Socket
        T1 - Route
Installed, T2 - Nexthop-override
        C - CTS
Capable
        # Ent -->
Number of NHRP entries with same NBMA peer
        NHS Status: E
--> Expecting Replies, R --> Responding, W --> Waiting
        UpDn Time

--> Up or Down Time for a Tunnel

 
Interface: Tunnel100, IPv4 NHRP Details
Type:Spoke, NHRP Peers:2,
 
 # Ent  Peer NBMA Addr Peer Tunnel Add State  UpDn Tm Attrb
 ----- ---------------
--------------- ----- -------- -----
     1 Old ISP IP       10.XXX.XXX.3   IKE   
1y15w     S
     2 Current primary
ISP IP       10.XXX.XXX.4    UP   
1d13h     S
                        
                             10.XXX.XXX.51    UP 00:00:30     D
 
Note – The output from the show IP NHRP NHS command from all
spokes is in the original post.
Also, I am still not seeing anything when I enter a show interface
status command on the hub.
Reboot?